Liczymy pasujące modele…
Standard Mega XL shells require sustained high pressure for the dart to exit the shell. Lower pressure blasters (like those I've made some adapters for to fire different ammo types) require 3 shots just to get the Mega XL dart to leave…
Due to the small scale & fine curvature of the scoop, use the smallest layers possible to ensure a smooth print. I highly recommend sanding with fine-grain sandpaper to smooth off any burrs.
This is a print-in-place Silly Shell adapter for the Finisher 3.1 allowing for different ammo to be used. It clicks in place of the drum so upgrading to the swappable drum is required, with an inset hinge that fixes onto the drum spinner…
I was able to source a spring from my local Ace Hardware store however it was wider than the original design's intended spring. This remix include a wider spring rod base so wider springs will catch and not partially go over the base. The…
After about a month of using a 3D printed plunger tube for my Finisher, the tube split at the layer line right as the tube begins to narrow because it was colliding with the piston with each fire. The PETG spring didn't help. I designed a…
This brake is specifically designed for the kiwico push and go walker wagon since it is light and rolls a little too quickly for new walkers. Remove the two screws and thread them through the walker and tighten until finger tight. Print…
To wszystkie aktualnie dostępne wyniki.
