Liczymy pasujące modele…
I needed a shelf for our son's IKEA Skadis system that keeps his GLIS Boxes nicely organized. Because I couldn't find any finished designs, I quickly created this one myself. The shelfs are of course not only working with GLIS, you can…
I was looking for an upgrade of the original Y-Rod holders that are shipped with the MK3/S and came across the one from MarcoZ76 which was going in the same direction I had in mind. However his Version uses a screw and I wanted it to be…
Update 03/24: While the original Version still holds up extremely well, I wanted to increase stability for the Front Wheels because there is quite some load on the original Wheel center rings. Those rings that come with the Kart are made…
Super simple design, prints and works great. I would recommend to use PETG if you plan to use it outside where it is expose to the elements. No support needed
This LED Strip Mount is based on two parts which can be connected to reach a total length of 400mm. I used Prusament PETG and wouldn't recommend PLA (believe me I tried and the 24V Strips I used get a little too warm for a longterm use).…
This is Version 2 of the IKEA Lack Printer Enclosure SwitchBox. One User asked to make some changes to the original Design and here we go. This design is made for 22mm Switches that require a 19mm hole. Version 1 can be found here:…
Print in horizontal orientation and with 6 Wall loops (100%) for strength. Should be printed with material that can withstand higher temperatures during summer. Support is recommended. Small pin needs to be inserted into the retainers…
I was looking for a simple Switch Box that includes a light switch as well as a Switch to turn on/off the Raspberry Pi that runs Octoprint. I therefore created one myself. The Switches are simple 15x21mm A Version for round switches can…
This Dust Guard protects the X&Y Axis rollers while machining. It has a 2.5mm slot on both sides to fit a piece of felt or brushes that can be cut to length for proper rail contact. The guards can be printed in any material and they are a…
I have created this mount to connect a Webcam or Gopro to the Bed of my Monoprice Select Mini. This mount was designed to use the standard screws (no extra drilling necessary). Print instructions I printed the pice PLA and ironed the top…
This case will fit the following 50MHz-6GHz Low Noise RF Amplifier Ultra
To wszystkie aktualnie dostępne wyniki.
