Liczymy pasujące modele…
Trijicon RMR to Holosun 407k / 507k adapter plate for Brownells Glock 17/19 RMR cut slide or MOS Version 2 Will require the slide posts to be shaved down about 1.5mm or so, you will also need to grind away some material from the 3mm nut…
An "all" printed compressed air engine. I have ran it up to 80 psi, the only issues are that the hoses pop off, and the bearings occasionally pop out. (-1% scale should resolve this) 1.6mm metric hex cap screws and matching nuts 30mm long…
Designed a bracket enabling the use of an auxiliary y motor to achieve significantly higher speeds on a gen 1 cr-10. I used 2 stepperonline .9° 1.5a motors, but have since read that 1.8° would have been a better choice. After getting…
Y axis belt tensioning bracket to aid with installation of my dual Y motor mod. Re-uses all the original hardware with the exception of 2 m3x30 bolts and 2 m3 nuts For the belt clamp please visit…
Skr mini e3 motherboard adapter plate, and cooling case for anet a8, due to lack of compatibility and not wanting to mangle the 2004 display I have chosen the cr-10 stock display. Note: sd card is not as easy to get to! you will need to…
Swapped the factory board for an skr e3 v2, factory motor keeps getting too hot, even at 50 milliamps. I have tried everything I can think of to get the motor to operate at normal temperature (switched polarity around, lowered current in…
Motherboard plate / adapter for tevo little monster or anet a8, tolerances are tight enough to thread if you would like to add on a cover for the anet, left room on the bottom for additional cooling and access to mosfet cooling pads.…
To wszystkie aktualnie dostępne wyniki.
