Liczymy pasujące modele…
This is a charging stand for the Amazfit GTS smart watch. You may need to lightly sand the hole where the charger pushes in from behind to make it a better fit. It needs to be tight but not so much it damages the charger. It will depend…
A friend has an Ender 3 V2 neo and their housing for the y axis limit switch broke. So rather than pay £20 for a replacement I modelled one up for them in FreeCAD. You will need supports for the main overhang but this is unavoidable as…
These are edges that you tape to a carboard spool so that it can run on a rolling spool holder like the one that comes with the Prusa Mini. These fit carboard spools such as those that come from 3DQF filaments. There are files for a full…
This adapter allows you to mount a Ravemen LR500S bike light/ torch to the underside of the included out front mount that you get with the Garmin 530 and other similar Garmin bike computers. Your out front mount must have the male Garmin…
Got a small form factor office PC that you want to turn into a gaming rig? I got you. This is is my mount that I made in about 10 minutes in TinkerCAD to mount a GPU to the outside of my Lenovo M720s computer. The GPU pictured is a second…
Introduction This is the "Toob" blaster I designed, it is inspired by the Sten gun from WW2. Like its predecessor I wanted it to be cheap and simple to make. The whole blaster is designed around 40mm PVC waste pipe. It uses the Cosmic…
This is a simple mini stock / pull handle / prime extension for the XShot Fury. You will need to take the existing screw out and drill the hold to 3mm then attach using an m3x25 machine screw.
Edit: I added WCARS from 1-12 degrees. I designed this to fit the new XShot Fury blaster. It uses M4x8mm machine screws and M4 Washers (instead of bearings). It seems to work really well and only loses about 5 fps. Let me know how you get…
I needed some clips to secure some 25mm flexible conduit. So I made these in tindkercad. Simple model but works great. I can print 16 in just over an hour with input shaper.
I tried a dozen different ways to print the and attach the pusher in the original file set. They all failed and stripped out. I noticed that the pusher nub that comes with the FTW solenoid does not fail and that it has an m5 thread…
I made a gryphon for my 9 year old and the the stock was too long for him. So I modified it to make it shorter.
A model of an 18th century french chanteaux I made in tinkercad.
I made a replacement dial from my Mum's 30 year old tumble dryer as the old one disintegrated.
This is the BaoBeacon. An inexpensive fox hunting beacon (< £30). It is based around the Baofeng UV-5R which can be had from Aliexpress for as little as £10 but usually around £15. You can even get them on eBay for less than £20 and from…
We acquired an Antilop High Chair for free but the clips on the straps were broken. I modelled this clip as a replacement. I initially printed this in PLA but it broke after the first dozen or so uses. I have since re-printed in ABS and…
With all Lynx style blasters I always accidentally drop the mag by activating the mag release on my tac gear when I should the blaster. I modified the OOD model to take a ball bearing detent. You will need a 6x7 mm ball bearing detent.…
To wszystkie aktualnie dostępne wyniki.
