Liczymy pasujące modele…
Remember: This model is not intended for the PicoStation PCB, but rather for a PCB-less installation (such as this one: https://www.reddit.com/r/psx/comments/1m4h7i3/wired_no_pcb_picostation_install_on_a_pu18_ps1/ ). The MicroSD to SD…
Fits this and probably similar motherboards
Battery pack, that fits two vape cells in parallel + TP4056 module. ADJUST THE CHARGE CURRENT RESISTOR ON TP4056! Should be printed from temperature resistant filament to handle soldering (of the contacts and on the tp4056 board). I used…
External laptop 9.5mm dvd drive case using PCB from broken Transcend external dvd drive. Needs 4 M2.5 and 1 M2 heat-set inserts and screws
Use this as wiring reference: https://old.pinouts.ru/Audio-Video-Hardware/MacVideoToVGA_pinout.shtml I used male DA-15 and female VGA connector as i wanted to connect it to CRT monitor with permanently attached VGA cable. The walls, which…
Print quality looks bad in the picture as i accidentally printed it with brim and it was hard to remove.
Designed in Siemens SolidEdge. Replacement body for Axagon 3.5 inch hdd caddy inspired by Playstation 2. The stock body has no ventilation and has resulted in my HDD overheating and dying. The fan can be connected to 7V (between 5V and…
Inspired by: https://makerworld.com/cs/models/1184571-usb2adb-converter-diy#profileId-1195420 Refer to the following page for wiring diagram too. The female USB port is the same as in the original model, e.g. a bare PCB-mountable one.…
To wszystkie aktualnie dostępne wyniki.
