Liczymy pasujące modele…
This tray is supposed to be mounted to the underside of a desk with VHB tape. It has a pair of knobs on the side so it will not fall out if you pull it too far. It's designed to push the bed size of the Bambu Lab printers to the limit so…
This is a small Poop chute for the Bambu Lab Printers (X1, X1C,P1S,P1P) I Recommend printing at .16mm layer height, deafult speed (you can easily print this in the sport or even the ludicrous mode), 100% infill This model uses less than…
This is a Cable Clip Designed to snap onto a 10x10mm mic arm and a 4mm diameter Cable, It is very easy to install as long as you use the print settings listed below. For a set of 15 clips you will need ~12g of fillament. Print Settings:…
You will need a 12(diameter)x5mm neodymium magnet which you have to place in the print at layer 82 (.2mm layer height) or just print with the 3mf file
I changed the Short Damper to acommodate a 17mm spring The Photo shows the original part that didn't fit
To wszystkie aktualnie dostępne wyniki.
