P
PrintablesKasper T
Lens cap for the DJI Osmo Action 4
A basic lens cap to keep my fingers off the Osmo lens. Printed in nice, ultrasoft TPE88 from Filament PM.
- Pobrania
- 408
- Polubienia
- 20
- Ocena
- 5
Wszystkie modele
Liczymy pasujące modele…
P
PrintablesKasper T
Measuring tool for inside openings
Tool conceived with a carpenter friend. Intended for use where a distance has to be measured from inside an opening, e.g from inside a door opening. It has been designed specifically to allow marking the corners too. It can of course also…
- Pobrania
- 153
- Polubienia
- 50
- Ocena
- 5
P
PrintablesKasper T
Very fine silicone cartridge tip
I needed a very fine tip to reach the bottom of some 5 mm diameter pockets while building https://www.printables.com/model/486656-magic-stargazing-binoculars Being not very handy with threads, I opted to remix an existing cap. Please note…
- Pobrania
- 115
- Polubienia
- 13
- Ocena
- 5
P
PrintablesKasper T
Mini Greenhouse
This print is a set of clips for upcycling an empty PET bottle into a small greenhouse. A large bottle is probably needed, I use 8L water bottles rather than 1.5L soda bottles, hence the need for four clips. The print has been designed to…
- Pobrania
- 37
- Polubienia
- 26
- Ocena
- 0
P
PrintablesKasper T
Carte dOr icecream organiser
This model is my most viewed by a very wide margin, but also one of my least downloaded. Apparently the premise is good, but the execution really sucks. So if you are one who found it interesting, but ultimately useless, could I bother…
- Pobrania
- 10
- Polubienia
- 2
- Ocena
- 0
P
PrintablesKasper T
Nozzle alignment aid
2+24-04-25 Obsolete? The new 6.0.0 firmware has improved its nozzle alignment so much that I can no longer detect any deviation from Perfect: https://github.com/prusa3d/Prusa-Firmware-Buddy/issues/3797#issuecomment-2063990752 ***…
- Pobrania
- 10
- Polubienia
- 8
- Ocena
- 0
To wszystkie aktualnie dostępne wyniki.