Liczymy pasujące modele…
The design files for these allow for making standoffs for use with 4-40, M3 and 6-32 screws. I have included various sizes for M3 screws. These are sized such that the screws should self-thread. The hex profile fits a ¼" wrench nicely.
32 line encoder for firm-fit press-on 10 mm shaft
This is a 1 part print. The inner core will separate when the print is removed. Wrap the fabric around the core, then side the outer clasp over it from the side. The core is loose but will roll and pinch the material to maintain a good…
This “builds out” an SG90 servo to mount where a standard servo (like AS-463HB) would normally be used. The best effort has been made to match the shaft position. The rear of the servo has not been built out.
This model is inspired by https://www.thingiverse.com/thing:2416859 I have included my source code. I made several modifications to this to make it easier to print and build. The rear cap is a separate component The shaft is printed…
This cat food dish is designed to have a large area, but be shallow with a steep edge rim and wide base. Because the dish shallow, the cat can get to the bottom without being strangled by the rim. The steep rim helps make sure catfood…
Its not for electrical connections, its just a mechanical strap.
pointer I made to fit on a 4mm stepper motor shaft. Print slow or the shaft mount will print like jelly and be all woogly.
just a basic mechanical clip to hold a 9V. Hmm, not the best photo, there are hooks on the bottom but that allow you to use a rubber band to strap-in the battery with, see my other 9V battery holder to get an idea.
To wszystkie aktualnie dostępne wyniki.
