Liczymy pasujące modele…
UPDATE: Version 3 included with better tuned dimensions and fixes based on feedback. UPDATED UPDATE: Thanks to Crosslink for featuring this in his video!! The extruder on the SV06 can get quite hot, due to the weak stock fan, especially…
Rather than buying one, print your own funnel to make sure all the grounds get in the portafilter. Use a food safe material and fill the print with perimeters. Should not require supports.
The Fysetc usb c input shaper devices work amazingly and are super cheap; just plug and play with no fussy wiring. I wanted a way to mount these solidly to the SV06 for measurements without using too much plastic. Came up with these…
Got sick of the low quality stock SV06 bearings, so purchased some sintered brass bushings to replace them. These need a shell to adapt to the LM8UU cavity. This is printed in halves, the bushing inserted and then the other half pressed…
Remixed the base of this to fit the guts of the below lamp: https://www.amazon.com/Crystal-Control-Charging-Dimmable-Romantic/dp/B0B2RDYQ3Q/ Or just search for “Crystal Table Lamp,16 RGB Color Crystal Light” on a platform of your choice.…
This is a clamp for various fixed angle knife sharpeners that stops the rod from moving too far in one direction, keeping your blade sharp and avoiding scratches. Print using 0.15mm layers (or thereabouts) and use a 3m bolt to tighten.…
This adapts a cheap drain odour valve/blocker for the more common 65mm drain/waste/vent pipe usually used in floor drains. Everything will press fit together and seal nicely while leaving enough room to easily remove it if required (using…
To wszystkie aktualnie dostępne wyniki.
