Liczymy pasujące modele…
This is a tool for cutting perfect 45° bevels in 6mm Depron/foamboard. It uses a regular shaving razor, which you insert in the slot. Place the tool on the edge of the Depron, slide along and you'll get a single perfect slice of Depron…
A beefy control horn (mainly for flying wings) that needs no Loctite to keep the linkage stopper in place. I needed a horn that would stop the little nuts from eventually flying off, and even though I use Loctite, sometimes the nut would…
The Timeframe uses a LilyGo T5 4.7" e-ink display to show you your daily calendar, agenda, todo list, photos, and anything else you want to show. Instructions on how to make it, along with code, are here:…
This is a tool for cutting perfect 45° bevels in 6mm Depron/foamboard. It uses a regular shaving razor, which you insert in the slot. Place the tool on the edge of the Depron, slide along and you'll get a single perfect slice of Depron…
I have the cheap and very handy DP30V5A power supply, and needed a case for it. I saw some of the other cases here but I wanted a barrel jack for the input and USB and XT60 for the output, so I can connect various other types of…
I needed a harness for my Mavic Air so I can deploy various payloads to it, so I designed one. It's fully printable, all-plastic and has a thick flat base so you can glue payloads to it. It fits exactly on my printer, I have also glued a…
A better firewall for the FT Goblin, with holes for the hot glue to "catch" better. Every other mount I used has come unglued because there's nothing for the glue to adhere to. This is designed for 16x16 motors, the OnShape model is…
I got a Blue Yeti X and I needed a pop filter for it, so I made one. It consists of two rings, between which you sandwich a piece of thin fabric, stocking, or mesh. I then used CA glue on the back side of the rings to glue them together,…
I needed a DJI AU/camera holder for my Drak, and I couldn't find one that was very light, let airflow through, held the AU securely but still took minimal effort to remove (so I can hotswap), so I made one. There's a latch that mounts on…
I remixed sporadic's dial gauge holder for two reasons: One, it wouldn't fit my v2.1, and two, I bought this dial gauge thing on eBay and it wouldn't reach far enough down to touch the plate. If you have a v2.1 and that gauge thing, this…
This is a hex key holder for the Wanhao Duplicator i3 v2.1. I needed a place to hold my hex keys, and I noticed a couple of small holes on the side of the gantry (probably for putting a z-switch on), so I designed this little part to go…
To wszystkie aktualnie dostępne wyniki.
