Liczymy pasujące modele…
A little bird. Based on several birb, including robin and tit. This model will be perfect on a shelve. Update : new version V2 with greater definition. I modified the belly and the beak to allow printing without supports. Selling printed…
A fast printed accessory for the Delonghi Dedica. It uses the ledge on the top and a hole present below. The main purpose is to hold the original measuring spoon/tamper but it can hold the "filter-holder" (?) too. Only 4g of material are…
A red birb. The last picture show how to print the main parts (support), you will need some glue for the face I highly recommend to print the face and the beak with 0.1mm layers (but it work with 0.2mm). The body can be printed with 0.1…
- Version 1, 14/03/2023 : A Northern Cardinal or Red Cardinal (Cardinalis cardinalis). This model is assembled with several parts and there are several poses available, depending on the parts you will be using. The crest has 3 positions :…
V3 : 01 02 2023 update New version with thicker walls for the face. It reduce the gap between the red part and the grey part.There are less fail during printing the eyes layers too. I recommend to print the gray part with a 48° angle to…
Why not? Everything can become a Minion :D Even ... a BANANA There are 3 differents eyelids to change the expression if you want. You will need to cut some rigid plastic sheet to make the "glass" part. For the expression in the center, I…
A cracked flower pot, I tried to highlight the cracks with some paint and sanding to keep the paint only in the cracks. It's inspired by Kintsugi art. The result is interesting but messy, the paint settles in the layers' hollows (I…
A little heart to make a pendant. It's a hard projet if you want to try bc it's complicated to remove the supports, everything is very fragile. Both face are identicals, in my case I added a little diamond inside then glued the two parts.…
There are 3 versions, one with sharp edges and one with rounded edges (to protect the plants or the fingers). The third is an in-between. The walls are thin ( 2.8mm) to reduce the use of material, I recommend to make 100% concentric…
To wszystkie aktualnie dostępne wyniki.
