Liczymy pasujące modele…
Tactical reload paper towel holder for IKEA Skadis peg board. Houses rolls up to 24 cm in length and 16 cm in diameter. I remodelled the original lever and added a curve to the roll contact face. Still fully interchangeable with the…
1/18 scale version of the original 1/10 by MrStolarsky. Pins were re-aligned and the whole board was made stackable. I test printed mine in resin and they came out awesome. I designed hangers for the Traxxas TRX-4M Defender, to hang a…
Battery holders/dispensers for IKEA Skadis peg board. 18650 Holds up to 9 batteries, works with protected cells as well. Both sides need to be printed. Pegs in the holder are ofset by 20mm to mount properly and not take up too many peg…
AA battery dispenser for IKEA Skadis peg boards. Has an open top to load the batteries in. Locking pegs' position has been adjusted to align the dispenser with my other dispensers. Houses 11 AA batteries. AAA battery dispenser for IKEA…
A simple shackle for my Traxxas TRX-4M Defender bumpers. Printed in resin and painted. Paper clip can be used to be pressed in to fasten it to the bumpers. Drop of glue might be needed at the ends to secure the paper clip in (I did not…
Wheels for the Traxxass TRX-4M Defender. All fit the original rubber and have the same offset as stock by default. Alternate versions with +X push the wheel out by Xmm, the wheel sits further out. -X brings the wheel closer to the body by…
Front light guard for my Traxxas TRX-4M Defender. I printed mine in resin and glued them on. Print some spares as the thin tubes might get broken in print (0.5mm in diameter). I printed 4 at a time and one guard had one bar broken.…
7mm long drive hex for the Traxxas TRX-4M Defender. I did not like how the axle thread is vissible with the stock hex drives (just asking to be damaged). This one is just long enough to have the nut flush with the end of the thread while…
Tray inserts for a LiFePo4 battery pack for UPS 12V7A battery case. I am using a 30A BMS to go with the battery pack made out of Liitokala 32700 LiFePo4 cells. Mine measured at around 6300mAh when discharged from full to 2.7V (per cell).…
After fooling around with 5" and a whoop, I decided to build a 3". But what fun would it be to design my own frame? Well, it worked out awesome. The frame is a TrueX, 130mm motor to motor. Overall weight (including props, battery strap,…
Top plate mount for GoPro Session 4/5 cage with back mounting. 4 versions: a - first version, directly replacing two top side plates (not recommended) b - second iteration of the a version (also not recommended) c - third version intended…
To wszystkie aktualnie dostępne wyniki.
