Liczymy pasujące modele…
Print with PLA on a flat side without supports, so it looks like an L from above. Use M3 or similar screws to mount the accelerometer to the part and itself to the extruder (check picture 1)
Printed in PLA. The model should be oriented like in the third picture, so that the larger bottom plane is facing downwards. Supports are needed. You can do it differently, but make sure to not angle the model in a way that supports are…
Ideally, turn the winding tool on a lathe. Stick it through the spool and mount it in an electric drill or similar, then wind your wire onto the spool.
Designed to be adapted to your own amounts and types of switches and buttons, Fusion 360 file “buttonbox_angled v16” is attached. Printable in any material, I used PLA for the boxes and panels and PETG for the mount/truss. Of course you…
Material and layer height doesn't really matter because the part is so small, but if you want to ensure maximum accuracy for testing, you can print it with a smaller layer height and with better filament. Also print hot enough for enough…
Printed in PLA with grate side downwards - 25min for me. Attach to inner wall of the brush like in picture 1. My rendition had a 4mm grate but I adjusted it to 2.5mm for the final model.
Uses a male JST-XH 3-pin connector on the bottom to connect to the printer body and a female JST-XH connector on the top to connect the lightbar cable into. In the center of the plastic part (cf. 2nd pic), the middle pin is soldered…
To wszystkie aktualnie dostępne wyniki.
