Liczymy pasujące modele…
Print in ABS or ASA, ducting is printed standing up, with supports to hold up the FC mounted part. Be careful when sliding it on so you don't knock any surface mount components off. Specifically the small capacitors near the stepper…
Snaps under the bed onto the 2010 extrusions and holds your bed wiring in place.
Made some mounts for a cable chain to be mounted in the FT-6 printer and hold the bed AC and thermistor wires. Using basic amazon 10mm X 10mm cable chain. Print Settings Printer Brand: Creality Printer: CR-10 Mini **Rafts:** No Supports:…
I wanted to be able to customize some of the parts on this printer since I am using different electronics, power supply, etc than what came with the printer. These are the basic shapes with bolt holes for basic assembly. I included the…
These are basically just gopro models, but in printable STL form with big cutouts in the back. Getting the right amount of ballast is tough. Good choices are either fishing lead, tire balancing weights or just go get yourself a roll of…
I wasn't especially happy with the stock mechanical switch solution on this printer, so I bought a couple of these: https://bit.ly/2maUa3B and started designing the mounts you see here. This replaces the Y axis stepper mount ACM part and…
Pretty basic to print. Use supports to get screw head areas, obviously the big flat side down. I printed mine at 50% cubic infill for the best multidimensional bend resistance. This has been tested and works great. Category: 3D Printer…
To wszystkie aktualnie dostępne wyniki.
