Liczymy pasujące modele…
This bearing is able to print in less than 2 minutes, not including the time to heat up the nozzle, which would take about 5 minutes. The default orientation will print just fine. Layer 1 defects like elephant's foot will most likely stop…
This is a jig for creating hydrogen gas via the electrolysis of water using 2 carbon electrodes from AA Carbon-Zinc batteries. The gas can be used as fuel once liquified, or used for lift in lighter-than-air flight. Assembly: Insert…
To print, knob should be on the bottom for the screw, and the knurling on the main part should point upwards. To attach to the cabinet: Put it on, then screw the screw in, or if you are not using the printed screw, drill, tap, then use an…
Everything can be printed without supports, and auto orientation is correct. To mould: Add pulp, then press with your hand, then check if the line inside is level: If it is level, put it in a vice, and squish as much as possible, add more…
To print: The base must be printed with supports. The side that looks like a recycling icon should face down to make the top face flat. The supports do not need to be removed. The plunger has overhangs, but its a filet-caused one, and is…
To wszystkie aktualnie dostępne wyniki.
