Liczymy pasujące modele…
Cup holder inserts into armrest wireless charger. Design is close to tight as you insert it so it does not move. I used a little strip of anti-slip mat meant for lining cabinets to tighten it up the rest of the way to avoid damaging the…
Stand made for Spider Gwen, but should fit other pop vinyl figures if the pegs are 15mm apart. Printed with .4mm nozzle, 10% triangle infil and is solid. One of the feet on the figurine is smaller then the other which I think is on…
This Brinkley Cup holder is designed to insert into existing holes in the factory couch after the original shallow plastic inserts are removed. These couches are most commonly found the Brinkley Model I travel trailer. Installation causes…
Use the Arm and Turntable from https://www.printables.com/model/136795-octo4a-phone-holder-to-run-octoprint-on-your-smart This is a designed from scratch model since I could not figure out the original's STEP file to change dimensions.
Mounts above Refrigerator in steel mounting plate. Model in picture was printed with .6mm Nozzle at .3mm Layer height. Required a brim to keep on the plate as it is printed in the same orientation as the picture to avoid surface defects…
Clips clock in and does not allow clock to fall off during travel but allows easy removable access to batteries. Print in PETG to avoid issues with the tabs breaking off.
To wszystkie aktualnie dostępne wyniki.
