Liczymy pasujące modele…
Spine model is split in 2 parts to make it easier to print without the support effecting the model quality. This is a continuation of my project of printing my MRI scan. You can check out my other model of mandible and part of maxilla if…
I used Heges iOS app with face id scanner to scan face. You will need to do at least 1-2 complete pass around face for a good scan. Then import it to meshmixer to clean up scan. Both complete parts (_comp) and split part to fit on ender 3…
I had to reduce the size of file to upload it, hence lower quality. (In Blender>import stl>decimate) Original stl after exporting from Meshmixer was 185mb. I can send you original file if you want to print it. Import your DICOM file in…
The snap fitting is bit difficult to snap on, I had to remove the caliper screw for piece to fit. Print and glue the AA cell housing separately so you don't have to use any support. For wire connection, I used a small piece of aluminum…
It's based of bootleg hotwheels that I found at a local store, made in CATIA v5
For printing in Ender 3 v2, scale down the models to 50%. I have split the complete model into multiple ones so it uses minimal support. The multiple part use push fit but use some sort of glue for better strength of joint. There's also…
Cap for Honda accent 2010 coolant reservoir. Been using it for 2 months+, there has been no issues with regards to thermal deformation on it. So feel free to use, but I would still advise you to check it once in a while if stills fit…
Internal taper and thread pitch To get the thread pitch I pressed my finger on the thread and measured the pitch from the indents. For internal pitch I scanned the handle to get estimate of taper.
To wszystkie aktualnie dostępne wyniki.
