10 modeli
Was noticing some bugs were getting into my tank, modeled up this lid to help reduce the problem. Would be best to add a food safe coating to the outside of the print since water can come in contact.
I purchased a paddle board that came with a Scotty mount location, since I didn't have much use for a fishing pole holder I modeled up this cupholder to use instead to keep my beverage secure on the board. Sizing is designed to firmly…
Took inspiration from a model I found on thingiverse but started from scratch to make the rail a bit bigger to add stiffness. Models include a portafilter holder, RDT bottle holder, general hook, and a tamper holder specifically for the…
This is a bubble level designed to work with M8 T-track systems on truck campers such as Lone Peak, Super Pacific, Tune, Etc. I tacked the bubble level into the insert with super glue to hold it in place. 10mm X 29mm square bubble levels…
Shovel rack designed to mount to the 10mm T-track on a Lone peak V1 Camper and store a standard short D-handle shovel. Files include multiple versions depending on your preference on shovel location; either front wall, side storage w/…
I designed a wind fairing specifically for the side T-track profile for the Lone Peak V1 Truck Camper. Designed to cover about a 150mm X 150mm packed profile of a side mount 270 awning (specifically the OVS HD 270 LTE Awning). Best…
I noticed that when overriding the door lock from the inside, the cables would poke my fingers so I created this cable cap that slides over and make the door latch easier to unlatch. Best print material is TPU, as it will be able to…
After knocking over my skis one too many times getting ready for the slopes on my tailgate, I decided to create a quick attachment to securely hold my skis out of the way of the tailgate and doors. Print with flexible like TPU to allow…
The are some terminal covers for the 12V in side of the Lone Peak Juicebox camper electrical system. Print with TPU and they should be flexible enough to friction fit on the terminals.
Latch covers for the Lone Peak V1 truck camper to keep dust and water out. Print in TPU and iron the top layer to get cleanest finish. Model uses QTY 12 10x2mm magnets set into the model during printing. Double sided 3M tape used to…
To wszystkie aktualnie dostępne wyniki.
