Liczymy pasujące modele…
This slider frame allows you to open the top lid for venting, bed access, and replacing the filament by sliding the lid back. Made this because model for three reasons: Don't like leaving the lid lying around where it may get damaged.…
Alternative methods to the one presented here. Just Skip to the 3rd and 4th Bullet! Simon Prevett at the QIDI Tech 3d Printer Owner forum described: If you cut a very small piece of ptfe tube and insert it into the head and leave it their…
Alternative methods to the one presented here. Simon Prevett at the QIDI Tech 3d Printer Owner forum described: If you cut a very small piece of ptfe tube and insert it into the head and leave it their then the next section of tube just…
After I managed to break these, I found other printable models, but none worked with the Smart Pro since they were optimized for other printers. I made these pieces to be close to Creality originals. The smaller piece that clamps the…
I could not figure out how to use the included Y axis stop mount, so made this one. Uses 2 M5x12mm screws with nuts. I printed in ASA, 30% infill. Holes for the mico-switch are not threaded, running a screw into each while forcing down…
To wszystkie aktualnie dostępne wyniki.
