Liczymy pasujące modele…
This tool will provide an approximation of how many meters of 1.75mm filament is left on a 1.0 kg spool. Measure from the level of the filament to the rim of the spool, as shown in the photo. I've tested it on my eSun PLA spools, and it's…
Printed using PLA+ Make the loop from 6mm bungee cord, and secure with a cable tie, as seen in the photos. Cut the bungee to length to suit the size of your bundle. These can be used for securing your hoses, sullage pipes or power cords…
When I purchased the AVX scope I was unable to get a crosshair to suit, so I made one. I've shot it extensively and it's held up OK. Printed with eSun PLA+ I chose orange as it was the best colour for contrast against the field and…
The nocks on my arrows are a particularly tight fit, and I made this tool to enable me to easily fit my nocks. Seat the nock on the pin in the arrow, place the nock into the tool, and then press the arrow down to fit the nock. The groove…
This is a secure and decent size headrest hook, which we use in the back of our 4WD. You'll find lots of uses for them. Designed using TinkerCAD Printed on a Prusa Mk4 using PLA, 5 perimiters and 25% infill. Print on the side and supports…
This is a remix of Rossum's great dispenser for AA and AAA batteries. I've tried several others, but none were as good as this, and I've modified it to better suit my own needs. Printed on a Pusa MK4, using PLA and no supports
My eSun cardboard spools dragged quite a bit on the Prusa Filament Spool Holder, and created cardboard dust. This bush allows the cardboard spools to spin more freely. Printed in eSun PLA+, with 4 perimiters and 15% infill.
This is the small plastic winder that opens and closes the ventilation hatch in your caravan bathroom. I found it too difficult to model the spline that it fits onto, so it's made slightly undersize and is therefore a rather tight fit.…
Printed on a Prusa Mk 4 in PETG, and using 100% infil. Supports will be needed. My reading and research suggests that this bracket will also hold the support leg for the Thule wind out awning, but I haven't tested that compatability.
This is a front lens cap for the objective lens on the Fujinon Techno Stabi 12x28 Image Stabilized binoculars These binos do not have objective lens caps as part of the original purchase. I've tweaked the model so they are a more precise…
This is a great model from Doug, and serves me very well, but I modified it to make room for a bit more dessicant. Printed on a Prusa Mk4, using eSun PLA, and with supports.
My friend broke the connection that joins the kitchen sink on his 2013 Avan 525 to the 19mm inside diameter drain pipe, and could not find a replacement. The existing collar that locks it in place was OK. The "Tail" on the original was…
To wszystkie aktualnie dostępne wyniki.
