Liczymy pasujące modele…
These hook caps install from the front at the hook points rather than from the back at the hook bends. This makes them less likely to fall off. Also, hooks with feathers or tinsel can be covered. To install, pass the hook shank through…
I usually buy 5 quart bottles of oil and they have a larger screw top than the old 1 quart bottles. Even some of the 1 quart bottles have gone to the larger top. Mobile 1 and perhaps other brands have an even larger top. So as re-mixes,…
With terminal tackle, there is often a lot of wasted space in flat tackle boxes. Several of the boxes pictured were near full and collapsed down to about half full using this tackle storage system. Using only the dividers provided by the…
For oil bottles with larger tops...
MK4 nozzle thumbscrews have been known to loosen on their own. My printer has experienced this phenomenon. This design hopes to lock them in place so that can’t happen. Before you install, have a look at your fan wire routing to ensure…
With the garage door insulation kit shown in the pictures, one clip gets bonded to the door, and the other engages it after being pushed through a hole in the insulation. The clips supplied in the kit can warp over time and disengage to…
This is a 2-piece, glue together design that avoids the need for supports during printing. It is a pretty good fit for a Ford F150 V8 oil fill funnel. It also worked well as a Mercury Marine 40 hp four stroke oil fill funnel. I used these…
Exacto knife blade cover for 5/16" (8mm) tool. Using a brim is recommended due to low surface area contact with the print bed. Use of PETG is also recommended because a PLA test sample lost most of its press fit over a short time.
This cover was designed to fit a 2” ball with the equator approximately 1.8” above the hitch (see picture). Try scaling in Z to fit other equator dimensions. The cover touches the ball at five discreet locations to avoid wiping grease…
Some of these olive oil bottle tops are pretty loose and could potentially fall out during use. The bottle top restraints included here will prevent that from happening. There are 2 different designs as one bottle that I have has a little…
This screw bit holder attaches to 1/4" pegboard so you can store bits in a handy, accessible way. There are 2 holder designs to choose from. One includes a pair of 3/8” holes to also store step drill bits or other tools as shown in the…
The recommended material for this slip on gripper is TPU. After printing, slide it on the original part and line up the gear and gripper radii. The gripper does take up some room so larger handle diameters that barely fit before may not…
I printed this using PETG at 0.3mm layer height with 3 perimeters and 15% infill without supports. PLA would probably be fine but could warp if left in a hot garage. To assemble, you may first need to straighten the wire if it is bent out…
To wszystkie aktualnie dostępne wyniki.
