Liczymy pasujące modele…
A friend of mine paints my models and needed something other than, according to her, ‘a lousy cup like a neanderthal’ (apologies to those who use a cup lol). Pillars were given slight tolerance to press fit. Glue if you wish of course.…
Just keep a heads up on the Top's first few layer adhesion. Suggested .2 height for overhangs. If the clips are too tight, I also included a more loosely releasing one woth a difference of .25mm. Enjoy! Be sure to check out my other…
I wanted to add a divot for the finger but that could be down the road. Tested and working! Again, all respect and thanks to the creator @kvlasblom for the original model. See below for full changes.
Print normally, manifold and hand made. Hang it up, use it as a table piece!
Friend of mine needed a card holder for her ID at work to just show at the gate instead of going through her pockets. So I made a clip that she can take her ID out and put it right back in! Suggested ABS/ASA for heat since it's in the car…
I made these for the contest but I ended up enjoying it a good amount so Enjoy!
Print the two halves on their flat side and the cube upside-down. Be sure to tack with glue at the feet :)
As the summary said, just a model for a friend. Hopefully others enjoy it as much as I did!
I printed the insert in TPU though I am sure PLA is just as fine.
- 40in² vented space - No hardware Necessary - Just under 850g of filament for all pieces (2 walls 15% cubic subdivision infill) - Super Glue optional - 10 pieces in total - Spool Riser with cap included - Minimal supports needed - No…
To wszystkie aktualnie dostępne wyniki.
