Liczymy pasujące modele…
This is a scoop to catch waste when drilling into a surface. This is meant to use on a wall or vertical surface. -- Print this flat and without supports. Category: Tools
These are corner protectors for sheet glass, specifically pinball machine playfield glass. There is a single model and a model with 4 pieces and connecting supports (to be trimmed apart later). -- This is printed on its bottom with no…
This is a tray to hold the laundry detergent cup during and after use. This fits over the opening where the cap would attach to. I have tested this and it seems to fit most larger detergent containers. -- This prints on its back. Brim is…
This is something I threw together to hold my sticky notes. I decided to create a few stencils to write lists for daily tasks and to-do lists. -- all of these print as it without supports. Storage - There is a short and a tall version.…
This is a wall mount for the US General or Kobalt Mini Toolboxes. I created this because someone suggested something with a dowel under the mounts to hang something (or hand towels). This uses a 1/2 inch dowel, 12 inches long. 280mm seems…
This is a level for pinball machine playfield. This is meant to be placed between the flippers to get a more accurate level. This supports be front to back and side to side leveling. v1.1 Did some minor cleanup and rotated the model to…
This is for redirecting the filament feed from the front/left corner of the printer. This works great with my filament spool holder. Category: 3D Printer Parts
This is a connecting ring to allow the US General and Kobalt mini toolboxes to be stacked. The lid can be opened, add the connector, stack another toolbox on top. UPDATE: I added a version 2.0 for those that want to modify their toolboxes…
This is a platform created for the US General and Kobalt Mini Toolboxes. This raises the box up enough so that you can open the bottom draw without hitting things on the table. There are two models and two versions. There is a model with…
This will be a collection of mods created for the ROKR Pinball puzzle. The puzzle is a kit that when put together is a playable pinball machine. Base - This is a frame that fits in the bottom cavity of the machine. When attached to a…
This is used to block any balls that may fall out of the trough when transporting or while the playfield is fully raised. To install this, just clip it around the apron support next to the ball launch. This can be done from the bottom of…
This is a grate to cover the garbage disposal drain. This keeps little fingers and utensils from going into the drain. This is for a standard 3.25 inch drain opening. It can be resized if needed to fit slightly different sized drains.…
This is a collection of hangers for hanging wires or cable from basement floor joists. -- These are printed right side up and without supports. Hanger (Clip-On) - This is a clip-on hangers that supports running cables either direction.…
This is a replacement joystick for the MegaTouch Ion Aurora. If printed with transparent filament, the led lights will illuminate the joystick. I created this a while ago and believe this was printed with supports for the bottom middle.…
This is for the service control panel mount on the MegaTouch Ion Aurora. This puts a space between the metal mount and also hold the board in place. This was printed on a raft and with supports. Category: Toys & Games
To wszystkie aktualnie dostępne wyniki.
