Liczymy pasujące modele…
This is the bulkhead fitting needed to install a valve in the wall of a rain barrel. While commercial fittings are available, they can be expensive. The ID of the fitting is sized for a ½" pipe thread valve (very common in the US). The OD…
Lense Hood for Tamron A005 70-300mm (62 mm). Hood may be mounted in normal position for use, or in reverse position for storage. Has detents which click on the small bumps in the lense's hood mounting tracks. I no longer have an original…
Short cups get lost in the cup holders of the 2013-2018 Toyota Rav4 (and perhaps other vehicles as well). There are other spacers on Printables, but they do not have notches for the tabs in the Rav4 cup holders. There is a short spacer…
I refurbished the book sharing library outside our local public library. I replaced the simple pivoting wood block latch with a printed latch which is a little more positive. The pivoting portion is countersunk for an average deck screw.…
I ended up with a used tote that was missing a latch, so I modeled one. I printed in PLA, 3 walls, 20% infill, and it is holding up fine so far. In the photos the black latch is an original Plano part, the grey latch is a printed…
The license plate frame on my car was wimpy, so I replaced it with this frame which is not. The model is half a frame, allowing it to be printed on many printers. Print two of the model and glue together (you may want to bolt to a license…
This is a spacer for Winnebago cabinet and drawer latches. On the two latches I have had to remove from my Winnebago Travato to repair/adjust, these spacers were cracked on both of them. This model is a direct replacement.
I have a lexan display cabinet mounted near a drafting table. I thought it would be appropriate to show some items related to drafting in the cabinet, hence a display stand for lead boxes. Overall height was limited by the position of the…
To wszystkie aktualnie dostępne wyniki.
