Liczymy pasujące modele…
Easy enough to open with one hand and locks good enough to keep moist in during the packages lifetime. Print without support. I printed at 0.2 in PETG. WetWipe_Base_Lid - Contains both the base and lid which is connected with a hinge. The…
The shade has a good gap to the lamp so the passive cooling design keeps working. I Printed in PETG @ 0.2
Collect water and don't introduce solids into your tank with a nylon sock filter! Snap on lid and smooth surfaces to keep the safe.
Reproduce of original cheap mini sprinkler “shrubbler” 360° mini sprinkler. Printed in PETG 0.2mm.
I printed flat with supports @ 0.15 in PETG
The original case broke a long time ago - and i had an ugly fix. These drivers is going into a drawer now, as a backup set, so i needed a way to keep them together without taking much room. The drivers snap into place, and don't slide…
Simple stand for Logitech c930e to get it up from the desk.
The edge of the can is 3mm high. The inner diameter of the lid is about 101.5 mm. I printed in PETG which makes the lid slightly flexible, the lid itself grips the can enough so that it is possible to lift the can holding just the lid…
In traditional net pots roots gets tangled, leading to disturbed roots if transplanted. With all that surface area building residue, its not easy cleaning them. These two flaws are targeted with this design. Since this is an assembled…
It's a must to print rails with some support, make sure to clean it out real well before putting the stop-inserts. Also recommended to add modifiers to enforce enforce the hook part with 100% infill. I printed in [email protected] Update Created a…
It's a must to print rails with some support, make sure to clean it out real well before putting the stop-inserts. Also recommended to add modifiers to enforce enforce the hook part with 100% infill. I printed in [email protected]
My mixer accidentally dropped and the plastic part holding attachments in place broke in two. It was previously somewhat damaged so that attachments was hard do remove from the motor part. Put the white plastic clip ring into the printed…
To wszystkie aktualnie dostępne wyniki.
