Liczymy pasujące modele…
Print Orientation It needs to be printed lying down, not vertically. Materials Go for something that prints with good layer adhesion. PC, PETG etc. TPU may work but like I mention below it tends to take a while to restore itself to its…
Material - something higher temperature, I used PC. There are heating elements just below the fan. Support material - not required. Print time (on my prusa mini) 42 mins. To take the fan out you need to have a triangular screw driver bit…
I really loved the idea of being able to free-form sculpt the track of a marble run through the air. This design tries to provide that. The track is connected to support rods by means of ball-jointed connectors that allow the angle of the…
Print it with the big flat side to the bed. It needed a little tidy up around the radius but other than that was ok. Print with supports. Use a UV resistant filament - ASA ideally or PETG.
To wszystkie aktualnie dostępne wyniki.
