Liczymy pasujące modele…
Updates: V1.1 - 1/14/2024 - Google depreciated their QR code generator. I have converted to using quickchart.io for QR code generation. Some changes in the setup instructions, some changes on the backend though. Changes noted here: ●…
USB A holder for a 1X1 Gridfinity. Holds up to 8 USB drives. Spacing is wide enough to hold most flash drives or adapters. Designed this to replace my old non-gridfinity holder that I have used for many years. Slight taper in the pockets,…
USB A & C holder for a 1X1 Gridfinity. Holds up to 4 USB A and 4 USB C drives. Spacing is wide enough to hold most flash drives or adapters. Designed this to replace my old non-gridfinity holder that I have used for many years. Slight…
USB A holder for a 1X1 Gridfinity. Holds up to 8 USB C drives. Spacing is wide enough to hold most flash drives or adapters. Designed this to replace my old non-gridfinity holder that I have used for many years. Slight taper in the…
Gridfinity 4mm driver bit holder. This model is a 2X1 Gridfinity base, that holds 30 bits, in a 6X5 bit configuration. I designed this to be as compact as possible, cramming as many bits into a 2X1 square that I could. Bits lay at a…
Gridfinity 4mm driver bit holder. This model is a 2X1 Gridfinity base, that holds 25 bits, in a 5X5 angled bit configuration. It can also hold up to 9 larger bits, up to 7.5mm in diameter. I designed this to be as compact as possible,…
Gridfinity 1X1 holder for three cables. Intended for use with USB charging cables, but can hold two cables up to 3ft long very easily. Print as many as you need, for the amount of cables you have. Cables are stored nicely vertically,…
Gridfinity 1X1 holder for two cables. Intended for use with USB charging cables, but can hold two cables up to 6ft long very easily. Print as many as you need, for the amount of cables you have. Cables are stored nicely vertically, making…
Gridfinity 1X2 holder for the Engineers 10' tape measure. Tape measure can be inserted either way into the holder. Best to print gridfinity base down, I don't use supports, and any layer height should work fine.
Angled mount for the Linptech mmWave ES1 sensor. Mounted with magnets to allow for easy sensor removal and attachment. Flat bottom on the other end, I have been using command strips to adhere it to walls. Sensor face is at a 50° angle…
To wszystkie aktualnie dostępne wyniki.
