Liczymy pasujące modele…
This was designed to work with this winder: I use the yarn winder in the highest cone position and fix it with a small tap. The other cones I used before were a little bit too small for this winder and had trouble to fit 100g of yarn.…
This version of the top plate increases the space to pass swatches in the top plate and moves the position of the top open yarn hole. The old position caused the yarn to get hooked onto the wheel screws if the tension was a little lower.…
A small cover for the punch cards. This fits to the inlay from Angst03 ( https://www.printables.com/model/433245-turing-machine-board-game-insert ). The game is stored upright and the punch cards have the tendency to fall out of their box.
Our store bottle which was refilled over and over again did not look so good anymore, therefore I designed this as a replacement. It prints without inner supports. I only supported the threads.
When I switch out my cylinder I want to keep it the ribber dial and the setup bonnet together. The Lid screws on. Because it is a a 7,5mm plastic rod it is not designed for strong forces but it is stronge enough for my usage. It is…
Note the picture it is best printed with organic supports on the side of the collectors,
While I know that I should count my stitches and rows for the full 10cm, I am usually too lazy. Therefore, I made this variant, which lets me decide each time, if I just want to do it for 5cm or for 10cm. I should have printed it with a…
There is a little bit to play in the insert. I noticed after printing that this could be reduced, but since it did not cause an issue it remains like this for now. The SolidWorks file is there if some one wants to fix it. I guess it will…
To wszystkie aktualnie dostępne wyniki.
