Liczymy pasujące modele…
Hi. I've designed a drill bit holder for Parkside 12V drill. It is implemented in provided magnetic holder groove. It is attached with super glue. It provides six slots for your drill bits. Design uses: six magnets d= 5 mm, h= 1.6 mm…
Hi. I've designed a simple holder meant for keeping glo Hyper Pro and pack of neo in place. The model has an open bottom for better ventilation. I've mounted mine on a double-sided tape in my car; it's works like a charm. Print Settings I…
Hi. I've designed a peg meant to mimic the original ones that I've bought with my outdoor blanket. It works fine with holding tent lines too, but only when the ground is soft enough. Print Settings I advise printing with PETG Print with…
The presented model is a modification of the Spigen Gearlock system. The solution shown is fully compatible with the mechanism used in this system. Depending on the variant of the mechanism you have, printing an additional Mechanism…
Hi. I've designed a corner cover for Baseus powerbank. Bottom and top of the case are opened for better heat distribution and access to ports. Sides fully closed. There is also an opening for a function button. THIS DESIGN COVERS CORNERS…
Hi. I've designed an attachment for Parkside dremel that holds the original wrench on the bottom of a tool. Dremel can still stand vertically with this attachment. It also fits the original case. I mounted it using superglue. The design…
Hi. I've designed a vent cover for GetFort rack. I'm using this rack as an enclosure for my printer. This vent cover design is meant to protect inside from dust and trap heat in. The vent lid is positioned on top of a base using a single…
Hi. I've designed a holder for my newly bought Werckmann utility knife. You can find this knife in Action store or buy it online. The holster was designed to hold the knife quite tight. It won't fall off even if flipped upside down. I've…
Hi. I've designed a simple switch panel with three slots. Slot dimensions are 9.50mm x 13.50mm. In the back there is an opening for wires. You can also drive wires through the third side of a model by drilling a hole in a surface you…
To wszystkie aktualnie dostępne wyniki.
