P
PrintablesFunky Dysfunc
Buck Converter USB Case HCW-P715
One base with screw holes, one without. The lid should be orientated so the lugs don't push on the capacitors. 0.20mm, shouldn't need supports.
- Pobrania
- 373
- Polubienia
- 39
- Ocena
- 4,67
Wszystkie modele
Liczymy pasujące modele…
P
PrintablesFunky Dysfunc
ABS Avocet Key Head
A replacement key head for ABS Avocet keys, bit rough but it works. I've had four of the original key heads break in the same way so needed some replacements. It's a one piece build and will require a pause set in the slicer to insert the…
- Pobrania
- 82
- Polubienia
- 8
- Ocena
- 5
P
PrintablesFunky Dysfunc
K3NG Rotator Controller Case
Arduino Mega mounts are set for 3m heat press inserts. You might need to trim some of the protruding pins on the bottom of the Arduino, or just remove them mounts entirely in the slicer if don't want them. There's room for a small buck…
- Pobrania
- 47
- Polubienia
- 1
- Ocena
- 0
P
PrintablesFunky Dysfunc
Kayak Paddle Holders
A pair of kayak paddle holders for mounting on the deck of a traditional sea kayak. Bungee elastic holding them together allows for quick parking of the full paddle or storage of a Greenland paddle. Print vertically, flat face on build…
- Pobrania
- 32
- Polubienia
- 9
- Ocena
- 0
P
PrintablesFunky Dysfunc
PTRX-9700 Reference Injection Case
A small snap fit box for the PTRX-9700 reference injection board to sit inside. Tight fit so print the base first then alter the size of both parts if necessary. Printed at 0.12 layer height.
- Pobrania
- 21
- Polubienia
- 1
- Ocena
- 0
P
PrintablesFunky Dysfunc
MSI Optix Mouse Bungee
A mouse bungee secured to the right leg of my MSI Optix MAG271CQR monitor. Should be fine with up to a 3mm cable. Wedge model works well with bungee cord. Have used heat gun to twist it slightly for better angle for my desk than as…
- Pobrania
- 19
- Polubienia
- 1
- Ocena
- 0
P
PrintablesFunky Dysfunc
N-Type Adapter for Keepteen D5 Solar Charger Meshcore
This adapter allows an N-Type socket with a short pigtail (5cm min) to be fitted to a Keepteen D5 Solar charging unit that has had it's charging board removed and replaced with other modules boards. There is a tilt on the adapter to allow…
- Pobrania
- 14
- Polubienia
- 4
- Ocena
- 0
P
PrintablesFunky Dysfunc
Enders' Revenge
Just something to stick where the QR code is on the Ender 3, Yar from my favorite Atari 2600 game Yars' Revenge. The Qotile for the other side if wanted has holes to push fit at the end of my rail, might not fit depending on the…
- Pobrania
- 4
- Polubienia
- 0
- Ocena
- 0
To wszystkie aktualnie dostępne wyniki.