Liczymy pasujące modele…
After I added a second z-axis screw and saw that my x-axis gantry was skewed I tried several variants of crash levelers. I would prefer to crash at the bottom since there are fewer variables that effect the level that you get on the x…
This fits under the filament run-out detector on the CR5. The PTFE tube runs from the dry box and connects to a PC4-M10 connector attached to the feed end. Screw the connector onto the feed end and then use 12mm M3 button head bolts with…
I successfully implemented this on my Ender 3. The system is comprised of the top wobble-x bracket, the left and right hangers, the middle wobble-x bracket (biscuit), the bottom bracket, and the z-axis motor mount. I use dual z-axis lead…
This is a plug that fits the 30mm diameter hole in the back of the CR5 enclosure. If you are not using the spool holder it seems like a good idea to plug the hole to keep hot air inside. It fits tight. I would only print this with TPU as…
A bust of Socrates. If you are a fan of his work this might just be a must have. "The only true wisdom is in knowing you know nothing."
This accessory rail fixture is for a strip of 3 LEDs on 8mm wide tape. The fixture is oriented in a semi-circle which has the nozzle at its center. Further the LEDs are slightly angled downward so that the light is centered around the…
This is a cable mount and holder for the Ender 3 with a direct drive extruder. The mount screws into the old Bowden extruder motor mounting plate. A small ball bearing is embedded into the mount and a capped shaft attaches the mount to…
If I don't eat anything I tend to bonk after 70mins. This basket makes it convenient to store some nutrition so that I don't have to get off of the bike to refuel. I like this better than a banana since its less messy. Look out Wilpers…
To wszystkie aktualnie dostępne wyniki.
