Liczymy pasujące modele…
This is a Bong/Waterpipe Bowl Holder & Herb Dish - 14mm as the title states. You can put your tobacco, herb, etc in the dish, stand up your bowl, and fill it without spilling anything! 1 version is tapered, the other isn't. This was…
This thing works great, I use it instead of trimmer line 90% of the time. A while back I had remixed https://www.thingiverse.com/thing:2438453 to add some (very thin) small flanges but never shared - these may break off but tend to help…
The PicoBucket: A great place to store your WaveBird receivers, Memory Cards, Carby, Carby Remote, etc! After installing the PicoBoot modchip into my GameCube that had a broken disc drive I removed the drive for faster boot times, less…
A universally mountable fishing pole holder. Two versions, one with no bottom to accommodate longer poles. Holder has slits for 1inch straps on the rear and holes (5mm rear, 10mm front) for you to pass screws & screwdriver shaft through.…
Remixed & Combined two models I found online in the same way I did the CaliKey. All credit to original creators! Notes: Can be printed on an FDM printer. Enjoy!
The Cartridge Steps, A Triumphant way to Display! Fits GB/GBC/GBA Carts. Fits 8 Carts. There are 3 .stl files; a blank one, one that says Game Boy, and one that says Cartridge Steps.
I love the original CaliCat I downloaded years ago. Remixed a blank keycap in ‘tribute’. Fits Cherry MX Enjoy! Notes: *20% Infill *No supports I printed in PLA. ***I do not know who to credit for the original Calibration Cat, but credit…
I am working on building my own desk, part of that will be integrated cupholders. This is an insert that drops into a hole and sits with a lip. It is sized to fit a soda can and have the top 40mm of the can stick out so it is secure but…
Just a Basic Parts Tray with a Lid. Has 12 deep holes, 8 half depth holes, and one cylindrical spot for screw bits or longer parts. Dimensions: 180mm x 130mm x 40mm Depths of compartments are 37mm & 18.5mm Width is ~29x28.5mm square…
Have a cluster enclosure for my array of rPi & 2.5" HDDs .. this is the mounting plate. Screw holes should line up good, the tabs you see on top and in rear would slide into holes of the same distance .. the L shape tab at the top flexes…
Remix of: https://www.thingiverse.com/thing:3769941 Added a third support so it did not sag, also added a side attachment for a chain to the X axis. Notes: No Supports Infill 20% PLA+ Shrink to 10% and put the largest flat side down in…
To wszystkie aktualnie dostępne wyniki.
