Liczymy pasujące modele…
I didn't like any of the existing models for the Sunlu Filament Dryer S1, mostly because the existing ones didn't really allow a PTFE tube to come in. My version allows you to screw in a PC4-M10 fitting, and allows the PTFE tube to go…
A holder for Expo Dry Erase Markers. The holes for the chisel tip markers are large enough that you can put the markers in upside down, allowing the ink to saturate the tip. Print Settings Printer Brand: Robo 3D Printer: R1 ABS + PLA…
I designed these for my school, the Cougars. Category: Keychains
Pirates Model Source - https://www.printables.com/model/309369-pirates-of-the-caribbean-aztec-gold-coin Avengers Model Source - https://www.printables.com/model/331847-avengers-logo Cars Model Source -…
This is simply a key hanger suitable for wall mounting with a sea turtle design and two screw holes. It has four posts that are tilted slightly upward so keys don't fall off. If I have time I may someday turn this into a customizeable…
I made a light switch for my sons' room. I covered the eyes from the back with electrical tape so you can't see the light switch hole. I printed it in Glow in the dark filament. Should work for single gang toggle switches. Category: Decor
It is a pepperoni pizza key chain. Category: Keychains
This is a remix of Lucina's case. I wanted one with holes so that my students could attach alligator clips. I found that 8-32 screws will screw into the holes of the microbit quite well, with no nut needed, allowing lots of room for…
I got tired of having to adapt my spool mounts to deal with the fact that Dremel sells their spools with tiny centers. To attach this, I drilled out the center of the spool with a 2 inch hole saw, and then added these adapters. This…
The block for the PLTW Automation and Robotics assembly line. I am not the one who made this, just posting it so others have access. Category: Engineering
These are numbers for Settlers of Catan. I made this solution because I wanted multicolor number pieces, but I don't have a multicolored printer. Print either the thick or thin version, as you prefer (I like thick because it is easier to…
This is a Valentine's day card I made for my wife to be from myself and our two kids. It consists of three cards that layer in with each other to make a 3 page greeting card. The first card says "Happy Valentine's Day", the next says "We…
My head is just too big for most hats, including the ones sold by Disney. I wanted to have an ear hat, so I used Tim J's model and rather than attaching the plates to a headband, I put them under a baseball cap that fits with the ears on…
To wszystkie aktualnie dostępne wyniki.
