Liczymy pasujące modele…
This is a modification of standard Voron 0.2 spool holder, made foldable. It's locking into folded position and extended position. This holder is extended from the standard one and should fit spools up to 85mm. Personally, it's a lot…
All the daylight on a matchstick mounts are made to be mounted on the top of the extrusion, making it not so elegant. I made a version that hides inside the voron's body, invisible from the outside. Placed at 45 degree angle so the light…
lego technic half beam cam Print Settings Rafts: No Supports: No Infill: 100% Category: Mechanical Toys
Bed nuts resized as much as possible - now tightening your bed is as easy as it could be
I opened the loop so PTFE is loose. You can now access the MOLEX clip. I recommend gluing this part to pcb cover for additional holding strength. I was frustrated that the default strain relief rubs belts a bit. Now it's more compact and…
Adapter for 48mm x 18mm compressor foot for voron 0. Minimalistic, fast print. Easy to install (use 4 M3x16BHCS bolts). Works with every voron0 model that has a flush bottom panel (remove foot skirts).
Auxiliary cooling fans for V0! Keeps a nice thin sheet of air flowing just below the nozzle. Can be used to heat up chamber when bed is high (door and tophat closed), or to cool down the bed (door and tophat open). With the arctic fans…
Gasket cutout was made using mouse model from rtings.com Gasket needs to be printed out of TPU. Depending of print settings, a bit needs could be trimmed from the front of the mouse buttons, as there's little tolerance caused by sharp…
Tophat support strut for Voron V0.2 Rises tophat by 5.5cm allowing air to flow Retractable, clickable into place Parts required: 2x M3x12 BHSC bolt 1x M3 nut Printing: Support required for arm at the hinge Mounting: hinge bolt to the…
Westie silicone mold - press 2 halves together witha a clamp or a vise, pour 2 compound silicone with a syringe through a bottom hole until there's silicone coming out from all ventilation holes. Wait 2-3 hours and remove the finished…
I wanted my sensecap to be smaller, in order to fit inside an enclosure. Now it's almost 2x thinner and also smaller in the rest of the dimensions. Airflow still possible with the vent holes, but typically the fan is almost always off.…
I made a few minor tweaks in its shape, so it fits more tightly and squishes the gears a bit more. As a result it will have much more space to actually grab the filament rather than stop at its resting position. It doesn't look any…
Replace standard cardboard fiberlogy core with this screwed core
Plate that holds fysetc ucan board in place, with holes for daylight wires to pass through.
Made with inspiration of https://www.printables.com/model/562384-voron-mini-stealthburner-ercf-filament-sensor , tuned the design for a better fit (original one didn't work)
ECAS04 filament inlet for Voron V0.2 (0 V0 0.2) dual purpose: bowden and bare filament Works well with ERCF ecosystem as well as with standard back spool holder. No need to readjust the pressed-in bowden tube each time you press it in. 1…
Remix of a great design, but that required M2.5 inserts. Now M2.5 bolts screw into ABS.
To wszystkie aktualnie dostępne wyniki.
