Liczymy pasujące modele…
Zero clearance insert for the Hammer C3 table saw. It probably also fits the Hammer K3 and Hammer B3. To limit the size of printer needed it is a 2 part model. The attached model are each time the front and back parts for both a 250 mm…
A print in place model of the Minecraft axolotl I've printed it in PLA with PETG tree support A support blocker for the neck joint Anti warp tabs on all all sharp corners
This is a dust shoe for the RatRig Stronghold One CNC with detachable brush and 80mm dust hose connector. For the mounting of the fixed part, it mainly relies on the available M6 holes in the front of the spindle bracket. I did modify the…
This block helps in setting up and improve the use of the Felder eccentric clamp 400-108. When setting up the clamp it is often difficult to gauge what clamping pressure you'll achieve at what height. This block speeds up this process if…
This is a modification for the top dust hood collection system of a Hammer C3 table saw and probably the Hammer K3 as well. It goes over to a 80 mm flex tube. It does require to cut off the top section of the standard hood. It is screwed…
A simple angle bracket that is capable of holding down the spoilerboard/waste board. It should be able to accommodate board thicknesses from 9mm up to 18 mm. It is intended to be fastened to the side profiles with M6 bolts (flat head) and…
A divider bin designed to be printed in vase mode with a parametric fusion model. The following parameters can be tuned (between brackets the dimensions of the stl): <width> of the bin(36 mm) <Height> of the bin(25 mm) <slotHeigth> (6…
Introduction With two of these you can create hard mechanical reference points to reliably square up both Y-axis Extra hardware: 2 * DIN 603 M6 x45 carriage bolt 2 * M6 nuts with nylon locking ring 4 * any type of M4x20 bolt Note: These…
To wszystkie aktualnie dostępne wyniki.
