Liczymy pasujące modele…
Heres a simple guage pod for desk use, designed for automotive 52mm gauges. I used the VDO clock from my old Porsche 924 turbo. Theres a hole in the back for power cables, regular 12v in my case. Printed without supports in my case, and…
A simple box to put Crealitys chamber heater in the Core One side panel to heat the primary print area, to make heating up in cold environments significantly faster. It works well and heats up the chamber very quickly in combination with…
The tool uses m3 allen head screws and nuts to lock the screws into place. I tried PETG and PLA, both works well since not alot of force is needed to get correct tension. I print without any supports, theres a thin layer that needs to be…
Simple case to store the Wolfbox MF50 blower, the lid is optional, you can put whatever gridfinity box on top instead. The simple pull over clamp might be adjusted in size to work with the material shrinkage you have, just adjust in the…
Screw cover to prevent the allen head from rusting away, need to grease it first. M12x1.25 designed for GT86/BRZ/FRS. Printed in PETG without supports.
A tool to hold a threading die (25mm diamter) made for 3/8 ratchets. Small holes for the holder are 2,8mm and threaded to M3, m4 could maybe work aswell. I printed it upright without support in PC-Blend at 0.15 layer height with 0,4…
A simple nozzle for increased access in very tight areas. Printed upright without supports, I printed it in ABS. The front of the nozzle is cut for increased access in corners. The Bosch text isnt included on the model for obvious reasons.
Replacement for the weak original (part number 62698627) Thetford fridge (camper van)hook that keeps the fridge open for ventilation. I didnt like the others out there so I made my own. Print it laying down for max strenght for the pins.…
I needed a slimmer wall mount cover that also was smoother so it could be covered in wall paper. I printed them in PETG without supports, and the fitted very well.
A quick print for a temporary indoor or outdoor table tennis setup, the wooden plank slot is 24mm and the table slit up to 17,8mm, m8 screws clamps it to the table.
With this tool you can double check that the timing mark is at the correct mark on the back of the pulley(as used on the Porsche 924 at least (not sure what side vw and audi uses). And you can double check after market wheels as i needed…
Simple gauge pod for 52mm gauges if you need a quick set ut up for some testing. Its open in the back for easy cable access. Made it for the FWLR knock detector, but should also fit other similar units. Made to print without support just…
To wszystkie aktualnie dostępne wyniki.
