Liczymy pasujące modele…
This is a remix of andrenauta's original From the original: Does not require any modification of the Autool, just slips in. It is secured to the bolts behind the dashboard. Print at 1:10 scale!!!
This just extends the guide along the back edge to give a bit more surface to align with. This is the right side corner only (my S1 Pro won't allow anything on the left side).
Recommend printing in PETG or ASA/ABS for sun/heat tolerance inside the car during hot summer days. There are 2 versions here: angled_flattened : This requires a few extra steps, but it gives a cleaner and stronger final result. Print the…
2x2 gridfinity holder for the silver Stanley 16' PowerLock tape measure. With the tape in the holder, this is just a skinny hair shorter than 6u.
The Lite version nixes the screwpad, but keeps the holder and fits in a 2x6 footprint. The Xlite version cuts out both and fits in a 2x5 space.
This is tailored to my specific setup and my specific equipment. Feel free to use it as-is, or maybe it can be inspiration for your own creation. Model files are as labelled. All the parts pre-assembled, and another with everything…
4-up glasses holder with inset for protective felt/vinyl/etc. Store your glasses lens-up OR lens-down – easy to grab on your way out the door. Print on its side, no supports needed. Use the included DXF file with your…
A neat little soap dish for the edge of the sink. Any water from your hands while pumping soap drains back into the sink. Has recesses underneath for rubber feet that keep just enough air space so water doesn't get trapped underneath. The…
Stops light glare from the light on the Ender 3 S1 Pro (or other printers using the same light bar)
My robot managed to break some teeth off a drive gear after a bit of a tumble and would only go in circles after that. Here's a new final drive gear to fix it. This (and the original) is a press-fit onto the axle, so you'll need either an…
To wszystkie aktualnie dostępne wyniki.
