Liczymy pasujące modele…
This remix adds the ability to use a zip tie to tighten up the mount. I liked the design but thought it was a bit loose. Since many of us have extra zip ties left over from building our printers, this remix just uses a single left over…
This remix adds a filament guide to the Filament Spool Holder 2021 by misterT. The pictures are of the 80mm version since that's what I needed. The files for the 100mm version are included but I did not actually print those. You'll find…
This is a 2x4 X-Cup bracket for the Bora Centipede. It comes in two parts that are easily assembled with a few light taps from a hammer or a mallet. If you're concerned that the post may back out, add a little bit of CA Glue (Superglue)…
The rear camera that comes with the RedTiger F7N Dashcam is intended to be mounted on the rear of the car and the bracket that in included is limited to mounting on horizontal surfaces. This bracket will allow you to mount the camera on…
A remix of the RepRack hanger without the mid rod mount.
I have a key for my RainBird sprinkler controller box and thought it needed a key fob so I don't forget what it's for. I included the original stl file so you can load it up and set your own print parameter or scale it as you see fit.…
To wszystkie aktualnie dostępne wyniki.
