12 modeli
I hated that some of these tubes of E6000 come with large nozzles, and I needed something more accurate for dispensing into cracks and such. Unhappy with the couple of nozzles I found online already that had different modeling defects and…
Never lose a drop of e6000 again! This thing adapts the e6000 nozzle to a luer lock so that you can load a glue syringe easily. To use: Screw the luer lock end on a syringe Jam the nozzle of e6000 in the other end Squeeze the e6000 tube…
First of all a big thank you to JeepingJohnny and all the predecessors in making these great models. With these models you can use E6000/S80 needles which are much easier to get in Europe. I had some issues with the rounded groove design…
The cap of my E6000 tube gets worn down way before I run out of glue. Now you can print a new one with improved wing grips! There is no threading, so be sure to twist it on hard the first time so the threading gets indented into the cap.…
I needed a wallmount for my E-bikes charger. I found a model here for another charger and i remixed it to fit the EC-E6000. The mount can be fixed with two screws, or with double sided tape like I did it on the side of a cabinet. I…
A larger tip version of the parent design, this one has a ~5.3 mm diameter hole instead of ~2.3 mm diameter hole. Print as with the parent.
Nozzle pin for E6000 adhesive precision tips. Use this to clear out the adhesive from the tip/nozzle after using the adhesive. Physical (printed) measurements: Pin length (circular): 32mm Pin diameter: 1.3mm Allow it to cool before…
This is a replacement cap for a 3.7oz/109ml tube of E6000 adhesive. I recommend printing in TPU for a good seal. I originally printed this in ABS, and it eventually became brittle and cracked (perhaps from the solvent in the glue?). The…
a simple e6000 holder for the hex peg board
Super Simple Design. So simple that I almost didn't even upload it, but it's been so useful for me, as I like to use the smaller tubes of E6000 because I can never seem to use a whole large tube before it dries out. Hope this can be…
Store or charge your Shimano BT-E6000 battery hanging on the wall. Mount with 4 screws that are appropriate for your wall material. I printed this in PETG material and mounted it using 4 screws. Other material may work as well. Invalid…
When the display is removed form the bike, a cover can be used to protect the electrical connections as well as avoid scratches on the surface, if put in a bag. The lid is locked in place when closed by bumps on the bottom part. There are…
