12 modeli
This very easy print can be swapped into the Ender3Pro within one minute and improves the part cooling capabilities significantly, without the need for a new fan. There are numerous highly respected YouTubers out there that have shown…
Wydruk około 0,34 €–0,42 € nettoWstępna wycena dla PETGMateriał u źródła: PET
You'll need four M5x12 and eight M3x6 for the linear rail block (M3x8 might work too, not sure) To install it, partially screw in the screw into the hex nut (use the stock ones) to lift the nut, and place the mount over the rail block…
Creality ender3pro fan duct
This is useful for hotend mounts that moves the hotend forward (like all of my designs for top mounted hotends, and likely many other), which usually lead to lost printable space, this gains 10mm back, for the full 235mm in Y But does…
This is a simple means to mount a 4020 blower to an Ender 3 Pro. Unlike many other designs, performance has NOT been verified with CFD :) But, I can confidently say that cooling is improved over stock and this machine will print bridges…
This filament guide for the Ender3pro is designed to be used with a Bowden tube and 2 push in fittings. In my case I used the stock parts of the printer after upgrading the Bowden tube. There are 2 parts in this design: 1 - Filament Guide…
Supporto per attrezzi per Creality Ender3 Pro da montare sull'alimentazione. Se apprezzi il mio lavoro e ti va di farmi una donazione =) Print instructions Category: 3D Printer Accessories Summary Supporto per attrezzi per Creality Ender3…
Remix based on model from Stuff Maker
Printed with Support Only touching Build Plate Filament PLA+ 0.2 MM layer height All other pars from original posting are still needed.
There is room for improvement and addon but it's a good solid starting base, installed, tested and in use on my printer. As of now it's compatible with Octopus mounting point ( v1.1, pro, EZ max ) and stock ender board pattern ( 4.2.2 &…
This is a fully redesigned Y axis setup, meant for ender3pro, ender3v2, ender3max neo and similar 4040 profile Y extrusion, front and back end holes needs to be screw tapped for M5 (already the case on ender3v2, and confirmed to be the…
