10 modeli
3 different logos from the great company that originated “DIY”. They're back, by the way, and selling kits again. Jointech made a very nice router jig and fence for cutting various types of joinery in wood. Both of these were requests.
The is a handle for a HeathKit VTVM's. It uses the screw hole spacing of 3 7/8" I found it printed best upside down. I used the existing HeathKit rolling thread screws for mounting. To do this, I heated the screw using a hot air gun, then…
A hex tool for adjusting vintage inductors such as those found in Heathkit radios. I used this to align my HW-16. I took the pic after it was well used so the shoulder is a bit chewed up from the inductor case tops. Print Settings Printer…
I printed the one in the photo out of PHA but I intend to replace it with a resin printed one soon. The set screw hole is 2.5mm while the shaft hole is 1/4". CAD files are included as well as copies without holes if one would like to add…
These are replacement paddles I made for my Heathkit HD-10 Electronic CW Keyer. I printed in PLA at Ultradetail settings. Had to design this after I accidentally broke a paddle in a move. The replacements work great and feel just as stiff…
The foam pad covering the sonar transceivers on Heathkit's Hero-1 robot typically decays over time. Print this model to replace it. This model may also work as a template for a new foam pad that could be cut with a hotwire (I haven't…
The circular tuning dial on my Heathkit SB-301 was so cracked that I was unable to change frequency more than a few hertz. Since these parts are hard to come by, I decided to make my own so I could use the radio while searching for an…
Attach handle using two 10-24 x 2" machine screws, washers, and nuts. Print four of the feet and attach using M4 x 12mm bolts with washers and nuts. First printed on Prusa i3 MK3S using white PLA to make sure the size was correct. Then…
The model is pretty self explanatory. The BOM will show what screws are required, and the assembly diagram will show you where they go. The case is meant to use an Adafruit seven segment display backpack. I didn't go with a newer high dpi…
This is a wall mount for a Heathkit Troubleshooter Volt-Ohm meter. The design allows the troubleshooter to slide in and out the top so you can easily remove it to use or change the battery. Category: 3D Printing
