Liczymy pasujące modele…
The sliding part is, I think, fragile (onto the shelf) → would be better to choose another material or change the propositions of the model :) CP
Wydruk około 2,38 €–2,91 € nettoWstępna wycena jednego wariantu
A Simplified version of the Shrine of Imam Husain in Karbala.
This is a photogrammetry 3D scan that I edited for 3D printing. It is a statue of Arethusa at the Louvre scanned by Benjamin Bardou. I smoothed and sculpted some areas and filled holes. I also scaled and oriented the model. The original…
Sadam Husain Rolls-Royce Corniche
Model je kombinací kreslení a tvorby v tinkercadu. Nakreslili jsme požadovaný tvar a poté ho exportovali do inkscapu. Odtud jsme ho převedli do formátu SVG. Tento formát byl importován do tinkercadu a výška nastavena na požadovanou…
This is a speedo holder for a Koso DB01RN for Husaberg 70° models with all wiring instructions. I made a 0° and 10° holder. You need to check which angle is better for you (because of reflection and the “bad” viewing angle of the display…
Vytvořil jsem úpravou model husy s otvorem na panáka a vytiskl. Panáka jsem tisknul pomocí vázového nastavení.
Husa Držák na příbory POKUD SE MODEL LÍBÍ DEJTE PROSÍM LIKE A STAHUJTE DĚKUJI
I recommend printing with 0.12mm, ideally with 0.08mm. That's due to the models small size.
one of the biggest challenges was to design the pelisse was the use the articulation of the dummy 13 while looking like the regiment and I think it turned out well note- the pelisse is only a shoulder piece and you still need to print out…
I was heart broken when I adjusted my desk lamp for the last time and the handle broke away from its head. It was surprising to see a design that put so much responsibility on bit of a plastic piece. It’s the Ikea HUSÅ lamp that uses a…
This is a holder for two Koso Coin temperature displays for the Husaberg 70° FS / FE 390 450 570. It fits perfectly (with the original hole) and holds very well in place. I would recommend to make it from ASA or ASA-CF to make it…
This is a holder for two Koso Coin temperature displays for the Husaberg 70° FS / FE 390 450 570. It fits perfectly (with the original hole) and holds very well in place. I would recommend to make it from ASA or ASA-CF to make it…
Husa Držák na příbory POKUD SE MODEL LÍBÍ DEJTE PROSÍM LIKE A STAHUJTE DĚKUJI
