F1-fighterJet
This is a fighter Jet that prints incredably good, if it fails then it is because of your printer because it is a clean 3D model
- Pobrania
- 91
- Polubienia
- 11
- Ocena
- 0
15 modeli
This is a fighter Jet that prints incredably good, if it fails then it is because of your printer because it is a clean 3D model
I printed mine with 100% infill and 4 perimeters out of PLA, probably TPU would turn out to be better, might give it a try later. The holes are designed for m4 screws.
We have a Wazer waterjet at the Fablab, and we were tired of using masking tape to prevent water and sand to come out of the sides of the door during cuts, so I made those joints. They just snap on the sides of the acrylic door et work…
80mm ⌀ Open-source 3D-printable waterjet for small-scale applications. Designed for use in an electric surfboard, with two units powered by two 3kW brushless motors. Could probably also be used in large RC boats, but doesn't support…
Printing with 30% has held up fine so far. For mounting, I would advice using all 4 screw holes, even though the pictures only show me using 2. Also I have the chairs hanging quite high and to make it easier to get a chair down I didn't…
Just add supports and make sure that your support settings are good or it will be very hard to take them off. Also, when taking off supports make sure that you don't take the rocket off.
ChairPad for Ikea folding - TERJE Category: Kitchen & Dining
Adaptador valido tanto para retorno de bomba como para aspiración (rosca DIN 81.934). Jet de salida a 90º (rosca DIN 41.91). Esta salida reduce considerablemente las turbulencias que dificultan la vista de la suciedad cuando se usa el…
Wall hanger for IKEA Terje folding chairs. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: Yes Resolution: .24 Infill: 35 Filament: add:north PLA Economy white Category: DIY
This button is for the Jeans. It may resemble a anatomical part, but do not get upset a it is simply an exclamation point surrounded by parenthesis. I really like this button! You can use a screw to assemble instead of the retainer back.…
A full size tire that was installed on a 1972 Ford Pinto and was driven around town in the Waterjet Channel's YouTube video. Made for the Prusa XL The video can be seen here.
A simple Figther. Based on the Grumman F-14 tomcat
Another Fire Fighter Toy... Take your garden hose (13mm Gardena standard)...and you have a sprayer Category: Outdoor & Garden Update: Scale now 125% (17mm outer diameter from hose should fit now)
This is a fighter Jet that prints incredably good, if it fails then it is because of your printer because it is a clean 3D model