9 modeli
Bottom is made for 3mm heatset inserts. I used four stick on rubber feet to stabilize the board since the gps module lives under there. A few dabs of hot glue will keep it in place. The holes for the screws on the antenna ring and the lid…
I have added a place for the GPS antenna to sit so that you do not have to hot glue it in. Also works with: https://www.thingiverse.com/thing:5532262
Joseph Hewett created a Wardriving PCB. I struggled to get all the parts into the recommended size case, so created this with a little more space. This is for the V3 board. Ideally the square window needs shrinking a little, (see photo)…
This model is a remix of JustCallMeKoko's C5 Wardriver shell !!!!! Make sure to check him out ( JCMK LLC – JustCallMeKoko LLC ) The changes I made to this model include: 0.4mm reduction to the back wall of the Magnet recess. Version of…
This case is a modification of Barry's wardriver case. Check the differences of the remix to see changes.
Edited the base to have 1mm shorter supports for the PCB.
In making HacerBox #0089, I decided to add female PCB Header Connector Strips to the circuit board so I could repurpose to parts. I liked AVERAGEGUY's 3D printer enclosure, but I had to modify it slightly to handle the increased height…
GPS Antenna should sit near flush. 201 Helix antenna does not cover SD card removal. Cut the well for magsafe ring deeper for stronger magnetic pull.
This is a parametric rugged box adapted to house five Seeed Studio XIAO ESP32-C5 boards. The setup consists of: 1 XIAO ESP32-C5 used as the controller 4 XIAO ESP32-C5 boards used as nodes A power bank used to power the complete setup The…
