Liczymy pasujące modele…
NOTE: I am still working on the RAMPS 1.4 config file with Marlin 1.1.0. Currently the printer does move around and extrude slowly, but not print worthy just yet. Testing parts to upgrade my 101hero from its gear reduction steppers to…
This is a case for the LCD2004 panel printable by the 101Hero. Thanks to RenatoT for the knob and BrantPeery for the base model for the shell. Print Settings Printer: 101Hero Rafts: Doesn't Matter Supports: Yes Resolution: 0.18mm Infill:…
The little plastic fantastic is a little wobbly out of the box. I made some X bracing to stiffen it up. The braces have holes for screws, but I just used some double sided tape and it sticks on just fine. 1 drawback is that one brace…
This is a pylon cap for increasing the structural stability of the 101Hero and was designed by Colin Klapka. This is being added here to keep all 101Hero upgrades I used in one place. Print Settings Printer: 101Hero Rafts: Doesn't Matter…
I took the top mount and made some adjustments for a sturdier fit. Inside the notched end is 20mm to prevent the bracket from sliding Two corners of the inner fill are curved so the bracket rotates in and locks. Print two of these to…
This is a remix of a fan shroud and the E3Dv6 carrier created for the 101Hero. Print Settings Printer: 101Hero Rafts: Yes Supports: Yes Resolution: 0.18mm Infill: 20% Notes: Supports to the bed are important. If possible, it would be good…
This is a hotend & active cooling carrier design for an E3Dv6 hotend and 2 40mm blowers. The fit of the ducts is very close to exact, so it may take some filing on the carrier to get them to slide into place. Once in place, I would…
These mounts allow you to hang the Sanguinololu LCD panel from the top of the 101Hero. Simply attach the mounts to the back of the board. The left hand mount has a cutout for the SDCard reader. Once attached, attach to the top of the…
This is a remix of Xerrako's struts to make a shorter set to be installable under the build plate to remove the chance of the arms striking the struts. Category: 3D Printer Accessories
This is a simple square dish for an upright NEMA17 (42mm) to sit in on top of the 101Hero frame and has a cutout for the motor connector. The two screw holes are spaced for the spare mounting holes at each tower. Print Settings Printer:…
This is a small clip to mount a Logitech C210 webcam to the top support of the 101Hero. The wide crossbar is meant to hold the support arm of the camera stable so you don't need glue/tape/etc. to keep the webcam in place. Print Settings…
Created by Xerrako's to make the 101Hero sturdier and less likely to move while in use. Print Settings Printer: 101Hero Rafts: Doesn't Matter Supports: No Resolution: 0.18mm Infill: 20% Notes: Supports shouldn't be needed. Category: 3D…
