8 modeli
Flywing makes amazing RC model helicopters that utilize GPS and other forms of stabilization. In my case I purchased a FW450L V3. A battery tray is an inexpensive part, but it is necessary to hold a battery pack inside the model. One tray…
The purpose of this chain guard is design is to replace the stock chain guard with 17inch Supermoto rims as the stock one is too large and will come in contact with the rear tire. Material used was PLA + (A Higher temperature withstanding…
Simple wall mount to allow for clipping the rear skid into and hanging vertically. I printed this with PETG, 0.2mm layer height, 30% infill, Grid infill and 5 layers just to make sure the ears were strong. I'm sure it's overengineered but…
A landing skid for my T-Rex 450L Dominator. The back is elevated a bit so the helicopter has its nose down by 5° and the back rotor come up a bit. Print instructions Category: R/C Vehicles Instructions I formed the skid by making it hot…
Dies ist eine Abdeckung für den Front oder Heckträger der CFMoto CForce 450 Wurde mit PLA 60% Infill Gedruckt
3D printed front wheel axle sliders designed specifically for the CRF450L for the protection of your precious bike., with Supermoto design and practicallity taken into consideration. Will require M8x20x10 threaded inserts and an M8…
This is a mount designed for a Honda CRF450L and a iPhone 16 Pro with a REEFLEX Case. The STEP file is included so the phone holder can be remixed for preferred phone/case combination. The bracket and phone holder are printed in PA11-CF.…
I recently bought a Honda CRF450L, fitted with Zeta levers. They are nice levers but the brake switch plunger actuator is just too short. As is, it lets the plunger pop out below the lever arm, leaving the brake light on. This model was…
