Liczymy pasujące modele…
I haven't done much printing, but I found that neither of my printers care for having the timing belt system going. They were both printing like crap, so for an acid test I took this off both any they started printing great again. So at…
Printed with PETG, 0.1 mm height, infil 5%, wall 2, top and botton 3 layers. Use Brim.
Hello, this is a small upgrade that the z-axis is holding in the z-axis guide without Wobbling. its easy to print and you can you how good your printer is calibrated :-D make it first over the Bearing and than in the z-axis guide its…
Einfacher Pulley mit 45 Zähnen für (zwei) 688zz Lager Print Settings Printer: TronXY X5SA Rafts: No Supports: No Resolution: 0.16 Infill: 40% Filament: GST3D PLA+ Category: 3D Printer Parts
I remixed TallackMedia Gridfinity 608ZZ Bearing Holder to hold 28 688zz bearings with both versions the 3u and the 6u Stackable. Both versions have tight tolerance to hold the bearings in place.
My CR10 is a bit modified and the Z steppers have been pushed away a bit from the normal position. This guide allows a wider range of distances but also covers the stock location. Use the bearing (F688ZZ Flanged) and screws (countersunk…
Another spool holder for Creality printers - this one is made to fit two F688zz bearings. Assemble using M8 bolt (50mm long at the very least) and a self-locking nut. My print settings: Printer: Creality K1 Material: PETG/ABS/ASA…
With this you can fit a 688zz bearing into a 608 bearing housing
adapter from 688zz bearing to 608 bearing
I remixed TallackMedia Gridfinity 608ZZ Bearing Holder to hold 28 688zz bearings with both versions the 3u and the 6u Stackable. Both versions have tight tolerance to hold the bearings in place.
This is a filament runout sensor mount for the Sovol SV06 based on the F688ZZ bearing I had lying around. This one fits on top of the z screws of the SV06 but I have been told inserting one there is a bad practice. The sensor attaches to…
Since I don't use the filament spool holder, the 1mm mount was a little weak. So I remixed it to 2mm, everything else is the same.
Simple print, you just need 4 688zz bearings that you push into a roller hole, Did not add holes for screws because i plan to use double sided tape.
components : 688zz bearing (x4) (d8 x D16 x B5) M3x15mm (x12) M3 nut (x12) Print with 10-15% infill and a little support
upgraded pin mod to 688ZZ bearings, need nema 17 with 8mm shaft minimum 30mm long
