Liczymy pasujące modele…
Print as shown on the screenshot, without supports. I've used 0.4 line width, 0.2 layer height, PETG filament. The part should fit very tigth inside the holes, use some force. No screws or glue needed. It doesn't make one-hand operation…
ENG: Thumb pin for the Gerber Armbar This model is intended for those users who own this tool and who prefer a simpler, one-handed opening with a pin to the awkward opening of the blade on the original. The pin is printed in about 11…
I wanted the extra strength from a second screw, so I remixed this. The original was great, I just wanted the extra strength from the second screw. I would definitely recommend PETG or PETG-CF for these clips. Use 2x m2.5 nuts and 2x flat…
Here is a quick and dirty holster for the Gerber Armbar. While I love the pocket clip on this tool, I find it's often too strong for my pockets and constantly gets hung up, not to mention my pockets always being full. If there is any…
To install guide the shim with the tweezers (SAK, Swiss Army Knife, 45.5mm size) and close the knife. After the tweezers and can slide in part way and then the needle (must be small diameter). The bottle opener locks it all together. This…
Quite simple Gerber Armbar Slim Holster with belt loop I love the small armbar but hate the keychain loop way of holding it so I made this belt holster the only thing needed to use this is to remove the keychain loop
Gridfinity Gerber Armbar Holder. 2 x 2 base, 25 mm height.
I wanted the extra strength from a second screw, so I remixed this. The original was great, I just wanted the extra strength from the second screw. I would definitely recommend PETG or PETG-CF for these clips. Use 2x m2.5 nuts and 2x flat…
Sleeve for the Gerber Armbar pocket knife. I removed the pocket clip from my Gerber Armbar and wanted something to stop the metal from hitting my phone in my pocket. My print cam out fairly stringy on the interior of the sleeve but I…
