Liczymy pasujące modele…
Modular synth module for Eurorack to attenuate/fade the signal. Quite simple to build as it only requires two resistors: one 10kohm slider pot and one 1kohm resistor. More details here: www.codeof.me/modular-attenuator-for-darker-techno/…
[Simple Attenuator Box] with 5 stage, for BNC connectors very useful for Osciloscope, Fox Hunting, Audio Tweaking/Freaking, Ham Radio… i plan on using Dymo tape on the face to mark the attenuation values. Material: 2X BNC connector 5X set…
General To keep the tiny SMA attenuators in order and because it is difficult to read the tiny text on them, I made this holder with big text for attenuation 1 - 1 dB 2 - 2 dB 3 - 3 dB 6 - 6 dB 10 - 10 dB 20 - 20 dB 6D - 6 dB with DC…
Simple enclosure for KC9ON's offset attenuator PCBA. There are two type covers. One is LED through hole and the other leaves a small amount of plastic to help attenuate the bright LED. Your PETG color will affect the light brightness as…
Holders for SMA attenuators inspired by https://www.printables.com/model/823220-sma-attenuator-holder but designed independently for individual configuration. Let me know if you need other values/configurations. The STLs just contain the…
This is a basic case for the KC9OF offset attenuator. The box is designed such that you can add SMA (female) bulkhead-style connectors to the side. I used RG-174 to connect them to the board. The lid to the case is locked in place with a…
This is a front panel for a 2HP passive eurorack multiple and attenuator. The potentiometer needs to be thin enough to fit under the panel. I added some photos of the potentiometer I used. You need to connect all of the tip lugs of the…
This case holds the ImmersionRC Power meter V2 along with a ufl-sma, sma adapter, antenna and i made it so it can hold my 10db Attenuator. Depending on your printer's settings you might need to run a file in the grooves of the cap and…
A very simple snap fid lid style box for the KC9ON V5 attenuator.
Needed to place attenuator between the Baofeng BF-H6 radio and antenna. Without proper housing it would be easy to break and look bad.
Case for fan and 40mm x 70mm attenuator and 40mm fan. Also used small 2 pin switch and dc 5.5x2.1 for power input.
The original mode is parameterised, new sizes can be created easily. It's designed for typical cylindrical body with cooling fins, and the port(s) along the central axis.
Set up the following way (back to front): 1 mm insert for thin PCB (Nooelec UWB antenna) 6x square holes for cheap Ali/Amazon probes 2 mm insert for normal thickness PCB (1.54 mm): H-Tool SL-10 mini LogPer antenne 2x mount for VHF and UHF…
Printed without supports out of PETG Model includes slots for two 3/16" zip ties for more positive retention. Not necessary but helpful when bushwhacking.
Needed to place attenuator between the Baofeng BF-H6 radio and antenna. Without proper housing it would be easy to break and look bad.
Set up the following way (back to front): 1 mm insert for thin PCB (Nooelec UWB antenna) 6x square holes for cheap Ali/Amazon probes 2 mm insert for normal thickness PCB (1.54 mm): H-Tool SL-10 mini LogPer antenne 2x mount for VHF and UHF…
