KC9ON Foxhunt Offset Attenuator V5d Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for the KC9ON Foxhunt Offset Attenuator (V5d) with SMA connections and an optional handle clamp.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 73
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a basic case for the KC9OF offset attenuator. The box is designed such that you can add SMA (female) bulkhead-style connectors to the side. I used RG-174 to connect them to the board. The lid to the case is locked in place with a single 4-40 x 3/8" screw that threads into a tab on the lid, no other hardware is required. I also designed a clamping mechanism so that I could attach it to my tape-measure yagi antenna. It specifically fits around this handle, and FWIW, I used these mounts to build the yagi. The clamp uses two zip ties that are about 1/8" wide. Make sure to use supports if you are going to print the clamp. I attached the clamp to the box with two part epoxy.